Bottom Ash Elbow Repair
The Problem
A Western Utility experienced leaking in their bottom ash transfer line. This allowedflue gas to be released into the air, and there was concern of an immediate pipe failure requiring an emergency shutdowm. Since this was the weekend, there was no chance of getting an immediate replacement.
This is a common problem as transfer lines carrying pulverized coal, fly ash, or bottom ash are subject to serious abrasion effects especially in the elbows and transition points. The enhanced abrasion occurs as the particulate stream is forced to change direction, impacting much of the particulate on the turning radius. Of the three materials, bottom ash is the most severe. Bottom ash, in addition to being extremely hard and crystalline has a wide range of particulate sizes. For example, “Black Beauty”, a commonly used Grit-Blast Media, is made from screened bottom ash.
The Solution
DUROMAR HAR, a two part, 100% solids, silicon carbide filled epoxy product was used to repair the elbow as it could be done in a relatively short time period.
To repair the damaged Cast Iron Pipe, the worn part was grit blasted to remove all surface contamination and oils. The part was steamed at 1800F for 4 hours and allowed to cool. The surface was reblasted and the steaming repeated. A final grit blasting is done to remove any released contamination and to give the surface a 3-5 mil profile.
Any worn areas were rebuilt with HAR, and the entire surface coated with an additional HAR at 80-120 mils DFT. For the large surface, a 5/32″ notched trowel was used to apply a first, grooved coat. This was allowed to become Tack Free, about 2 hours, and a final build coat is applied with a smooth, rubber trowel. The HAR was heated to Force Cure the repair @ 1800F for 3-4 hours, cooled, and returned to service.
The Results
The cast iron elbow was repaired during an eight (8) hour work shift. It was returned to service, and the plant resumed operation. The repair performed so well that the replacement piece was not installed until the plant was shut down during it’s next scheduled outage, over a year later.
Current Status
HAR is now used as the repair of choice when dealing with worn bottom ash piping. In many cases, it is applied to new pipes and elbows to make repairs faster and simpler as they wear.